|
Article: Black 1/4" Nylon Cable
Sleeve
Date: Tuesday, September 7, 2002
Author: Bruceleeon
Provided By: None
Page: 2 of 4
Now this is the FUN Part. You are
going to use your precision screwdriver to reach in and bend back the fins
onr your wiring. This can become very tedious when it comes to
doing this mod on your powersupply because there are so many.
You want to be careful not to bend
them in too far becuse you will have to bend them back out later
in order to put them back into the molex's.
Also, you don't want to scar anything,
so I recommend being very patient and not trying to rush this
process along.
You are going to have to remove
both the molex and the passthrough in order to get your heatshrink
tubing and nylon cable sleeving over the wires.
Back Next
|
|
|
